We bought our home with a sauna already built in. About a decade ago we stopped using it and it became another closet for storage. After my trips to Winnipeg and Fort St. John, where I used saunas to relax, I realized I want our sauna back.
Yesterday, I cleared it out and set up the benches again. I vacuumed up the cobwebs and dust from the walls and heater. I turned on the elements and the heat was returning. The smell of the remaining dust burning off was strong. However, shortly after the heat stopped working. So much for relaxing on a Saturday night.
How do you troubleshoot a sauna built in the 1970’s? I seriously have no idea where to begin. It obviously was getting power. My guess is that it could be one of three things-
- The thermostat is toast.
- The elements are toast.
- Perhaps there’s a fuse or relay switch that’s toast.
It’ll have to wait until my next set of days off. But how do I go about checking these things? I need to see if there’s and obvious fuse somewhere either in the controls or under the burners. That’s where I’ll first start. I really hope it’ll be something simple. I’m not sure what the cost would be to replace the entire heating mechanism. As well, the thermostat is built into the wood walls and I don’t really want to start tearing apart the sauna.
I’ll post an update if I eventually figure out the issue. I’ll need to relax once this is all sorted out. Wish me luck. I’ll also take any advice you have to offer.